Sound To Eject Water and Dust From Phone Speaker

How to Use
  1. Set your device volume to ~80% (recommended level)
  2. Place your phone with the speaker facing downward
  3. Auto Mode is selected by default for best results
  4. Press Start and let it run for the full 45-second cycle
  5. A 30-second break happens between each cycle
  6. Complete all 3 cycles for best results
Important
  • Avoid using maximum volume
  • Keep the phone still during the process
  • Complete all 3 cycles for best results
Auto Mode

Recommended for most cases

Manual Mode

Fine-tune frequency control

Vibration Mode

Uses device vibration motor

Break Time: 30s
Time: 45s Cycle: 1/3 Mode: Auto
0%
165 Hz

What Is Speaker Cleaner?

Speaker Cleaner is a simple web tool that helps fix muffled phone speakers by removing trapped water and dust. It uses sound vibrations at specific frequencies to push out moisture and dirt. It does not rely on taking your phone apart or using harsh methods.

Why Should You Remove Water and Dust from Your Speaker?

When water or dust sits in your speaker holes, it can reduce sound quality and cause permanent damage. You may hear low volume or distorted audio. Removing unwanted particles right away is a safe way to maintain clear sound.

How Does Speaker Cleaner Remove Water and Dust?

Speaker Cleaner plays a special tone that creates strong vibrations. These vibrations shake out droplets or debris that block your speaker. Some phones have a built-in water ejection feature, but Speaker Cleaner provides a similar effect for almost any device.

How Do You Use Speaker Cleaner?

  1. Disconnect headphones or Bluetooth devices.
  2. Turn your volume up.
  3. Run the Speaker Cleaner sound for a few minutes.
  4. Check your speaker opening for any remaining water or dust.
  5. Repeat if the sound still appears muffled.

What If You Still Have Problems?

If salt water got inside your phone or your speaker still sounds bad, consult a repair service. Speaker Cleaner helps with normal water and dust, but severe damage may require expert attention. Keeping your speaker area dry and clean is the best way to prevent problems.

Why Does Speaker Cleaner Use a Specific Frequency?

Speaker Cleaner relies on a 165 Hz range because it produces strong vibrations that help loosen particles without harming your phone. This approach is similar to methods used by some watches to eject water.

Speaker Cleaner can fix your speaker in many cases. It offers a direct way to remove water and dust so your audio can return to normal.